idME+ (remoteID)

With GNSS and pressure sensor

  • It is equipped with a high-quality multi-GNSS receiver and a barometric altitude sensor
  • After equipping with GNSS, it becomes to independent device from the autopilot – it only requires a power connection to function
  • Designed to meet requirements of remote drone identification and localization in ASTM/ASD-STAN standard.
  • Using the BLE broadcast technology the device provides surveillance and drone operator identification capability based on any modern mobile devices such as smartphone or tablet.
  •  idME can be easily connected to Pixhawk controller via JST connector. For full operation, a position source (along with other parameters) is required, which is obtained directly from the MAVLink protocol. 
  • Small outline and low power consumption allow it to be used in ultra-lightweight drones. AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.
  • NOTICE:
    – FCC/CE certification pending
    – in accordance with F3211-19, published in February 2020.

Features:

Application:

Compliant with ASTM and ASD-STAN
Broadcasts remote ID messages
Be visible in the airspace, let the safety level rise
Maximize the range of the broadcast receiving

See beyond

Basic Electrical specification:

ParameterDescriptionValueUnit
TX powerBluetooth+8dBm
Power supply V
Current consumptionaverage60mA
Dimensionsmain outline31.5 x 15.5 x 7.3mm
Weightwithout cable6g