The most advanced version of Remote ID: idME PRO

NEW PRODUCT - ID ME PRO - social media

idME PRO - remote ID with WI-FI and BLUETOOTH

In response to the market needs, Aerobits has launched the most advanced version of Remote ID: idME PRO which, as previous versions of idME family, provides enhanced identification and tracking for unmanned aerial systems (UAS), but this time it is based on two technologies: Wi-Fi (NAN and Beacon frames) and BT (BLE, and legacy frames), moreover additionally it can be equipped with a GNSS reciever with antenna.

This product uses BLE (Bluetooth Low Energy which supports Bluetooth 4.0 and 5.2) to provide surveillance and drone operator identification capability via modern mobile devices such as smartphones or tablets. This device supports WI-FI (NaN, Beacon) frames and can be easily connected to the Pixhawk drone controller via a JST connector.

For full operation, a position source (along with other parameters) is required, which is obtained directly from the MAVLink protocol. AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc.

Small outline and low power consumption allow it to be used in ultra-lightweight drones.

NOTICE: idME PRO has been developed in compliance with the newest version of ASTM and ASD_STAN documents.

Interested in this solution? Go to the product page or write a message to sales@aerobits.pl

Skip to content